Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Vehicle with Manual Transmission:
– Remove -2 to 5- that are accessible from above that connect
the engine to the transmission.
– Remove the starter slightly from the transmission and leave it
in the installation position.
Vehicle with Dual-Clutch Transmission:
– Remove the bolts -2 to 5- that are accessible from above that
connect the engine to the transmission.
Continuation for All Vehicles:
– Position the -10-222A- with the -10-222A/22- on the left and
right fender bolting edges as shown.
– Connect the transmission and -10-222A/11- with the -3147- .
(Shown with the engine removed.)
– Slightly pre-tension the transmission using the spindle.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
1. Engine, Removing and Installing 15
To Next Page
Loading...
