Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove the nut -2- and free up the bracket with the wire.
– Remove the bolts -arrows- and remove the right engine sup‐
port -1-. (Shown with the engine removed.)
Installing
Install in reverse order of removal and note the following:
• Replace the bolts that were tightened with an additional turn
after removing them.
– Follow all steps after connecting the battery. Refer to ⇒ Elec‐
trical Equipment; Rep. Gr. 27 ; Battery; Battery, Disconnecting
and Connecting .
Tightening Specifications
♦ Refer to ⇒ “2.1 Overview - Subframe Mount”, page 35
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
1. Cylinder Block, Belt Pulley Side 51
To Next Page
Loading...
