Audi A4 2015 - Page 79

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Disconnect the connectors and free up the wires:
1 - For the Camshaft Position Sensor 3 - G300-
2 - For the Oxygen Sensor 1 Before Catalytic Converter -
GX10- (remove from the bracket to do so)
3 - For the EVAP Canister Purge Regulator Valve 1 - N80-
– Remove the ignition coils. Refer to ⇒ Servicing – 4-Cylinder
1.8L; 2.0L 4V TFSI Engine; Rep. Gr. 28 ; Ignition System;
Ignition Coils, Removing and Installing .
– Disconnect the connector -2- for the Charge Air Pressure Ac‐
tuator - V465- .
– Disconnect the connector -3- for the Turbocharger Recircula‐
tion Valve - N249- .
– Loosen the hose clamp -1-, remove the coolant hose and free
it up.
– Free up the wires.
– Release the catches in direction of -arrows-, remove the wiring
duct -1- with the wiring harness and set aside.
– Loosen the hose clamp -2- and remove the hose for the EVAP
system.
Audi A4 2015 ➤ , Audi A4 China 2016 ➤ , Audi A5 2016 ➤
4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888 Generation III) - Edition 11.2019
4. Valvetrain 73