88
10
SwitchiR Infa-red
Controller
Menu Description
Fr Press OK to read the transmitter or receiver
frequency setting. Press OK again followed by
a or v to select a new frequency, and press OK
to transmit to the unit.
AF Press OK to read the receiver or transmitter
audio level. Press OK again followed by a or v
to select a new audio level and press OK to
transmit it to the unit.
LF Cut Press OK to read the transmitter’s LF cut setting.
Press OK again followed by a or v to switch
the setting between on or off and press OK to
transmit it to the unit.
Batt Press OK to read the transmitter or receiver
battery level. For receivers the receiver battery
level alternates with a transmitter battery status
indicator: H (high), L (low), or F (fail).
Int Batt Displays the battery voltage of the Switch
iR
internal battery. If this falls below 5.00V the
internal battery should be replaced.
9V Batt Allows you to test a 9V 6LR61 type battery by
holding it against the two metal terminals on the
side of the Switch
iR
. A reverse polarity warning
is displayed if the battery is connected the
wrong way round.
Sn Press OK to read the serial number of a receiver
or transmitter and display it on the display. The
serial number consists of a six-digit prefix
followed by a two-digit suffix, and these are
flashed alternately on the display.
User ID Displays the unit’s user ID. You can edit the user
ID using the Aud
iR
application.
iR disable Press OK to disable the infra-red port on a
transmitter or receiver until power is
disconnected and reapplied.
Off Press OK to turn a transmitter off. Not available
for receivers.
To Next Page
Loading...