Audio Ltd. Envoy - Infra-Red Disable

88
26
HXiR Hand-Held
Transmitter
• Align the front of the Switch iR with the infra-red port
on the transmitter and press OK.
If the command was received successfully the new
setting will be displayed.
For example:
Tx
On
Otherwise the display will show:
Error
• Repeat the above steps if an error message is
displayed, with the Switch
iR closer to the receiver.
To check the battery status
• Press MENU.
• Press a three times until
the display shows:
TxRx
BAtt
• Align the front of the Switch iR with the infra-red port
on the transmitter and press OK.
The display will show the
current battery status:
Tx
1.25v
The battery level can also be checked from the receiver;
see the appropriate instructions for the receiver.
Infra-red disable
You can protect the HX iR from an accidental change of
settings, such as in a live performance, by disabling the
infra-red port on the transmitter. This will prevent all
communication to the transmitter until the battery is
disconnected and reconnected.
To disable the infra-red port:
• Press MENU.
• Press v twice.
The display
will show:
TxRx
dISABLE
TxRx
Ir ?
• Align the front of the Switch iR with the infra-red port
on the transmitter and press OK.
If the command was received
successfully the display will show:
Tx
Ir OFF
HXiR Hand Held
Transmitter