Audio Ltd. Envoy - Fitting Microphone Capsule and Handling

88
27
HXiR Hand-Held
Transmitter
○○○ ○○○○○○○○○○○○○○○○○○○○○
Fitting the microphone capsule
The HX iR transmitter uses high quality interchangeable
condensor capsules from the Schoeps Colette range.
The HX
iR is compatible with the full range of capsules
and accessories in this range.
The capsule mounting has been specially designed by
Rycote ™ to minimise the handling noise.
To fit a capsule
• Unscrew the metal windscreen from the top of the
transmitter.
• Screw the capsule into place taking care not to
cross-thread the capsule or over-tighten it.
• Replace the windscreen.
○○○ ○○○○○○○○○○○○○○○○○○○○○
Holding the HXiR
The HX iR should be held above the illuminated indicator
ring. This will enable maximum power to be radiated
from the integral antenna in the battery compartment.
Holding the HX
iR over the battery compartment will
impair the range of the transmitter and should be
avoided.
The frequency, gain, and LF status setting will be
retained even if the battery is removed from the
transmitter.
An external foam windshield is available from Audio
Limited.
HXiR Hand Held
Transmitter