Audio Technica 3000 Series User Manual

29
5
When “Group” is selected, select the group to be scanned and press the SET button.
• When “Full Group” is selected, this step is not required.
6
Select the scan sensitivity from “Normal”, “Low” or “High” and press the SET button.
Scan starts. Please wait a moment.
7
When the scan result screen appears, check the screen.
• The number of open channels available for the selected group is displayed.
When
you scan in “Full Group”, you
can check the open channels of all groups by pressing the UP/DOWN but
ton.
• When “Retry” is displayed, scan again.
8
Press the SYNC button and place the IR sync window of the receiver so it is facing the IR sync window of the
transmitter.
• Wait several seconds until communication is established.
Once the transmitter and receiver are synchronized, the “RX SCAN DATA” screen will appear on the transmitter.
Caution
• IR SYNC cannot be performed correctly if the transmitter and receiver user group settings are different.
If IR SYNC fails, check the user group settings.
Performing full scan
1
Press the SET button on the receiver's main screen.
2
Press the UP/DOWN button to select “SCAN” and press the SET button.
3
Select “Full Scan” and press
the
SET button.
Scan starts. Please wait a moment.
4
When scanning is complete, press the SYNC button and place the IR sync window of the receiver so it is facing the
IR sync window of the transmitter.
• Wait several seconds until communication is established.
Once the transmitter and receiver are synchronized, the “RX SCAN DATA” screen will appear on the transmitter.

Audio Technica 3000 Series Specifications

General

Brand	Audio Technica
Model	3000 Series
Category	Microphone system
Language	English