28
Useful functions
Performing RF scan
Use RF scan to analyze the surrounding radio environment and set the available frequencies. There are three types of
scans.
Scan the frequencies in the group to set the available frequency channels.
This is useful when finding available channels in a user group.
Find all available frequencies in the available bands in 200 kHz steps.
After synchronizing the scan results with
the transmitter via IR SYNC, the
scan results can be displayed on the transmitter and used for frequency
coordination in a dedicated software (Wireless Manager).
The last scanned data is synchronized with the transmitter via IR SYNC.
This is useful when you want to set the frequency again from previously
scanned data.
• When performing RF scan, the transmitter should be in RF OFF mode. It affects the results of the RF
scan.
• Wireless systems may be affected by the spark noise of vehicles, dimmer of lighting apparatus,
computers, office automation apparatus and electronic musical instruments. When performing RF
scan, turn these devices off.
• When performing IR SYNC after RF scan, IR SYNC may not respond if the transmitter has just started
up. In this case, perform IR SYNC again.
Performing a group scan
1
Press the SET button on the receiver's main screen.
2
Press the UP/DOWN button to select “SCAN” and press the SET button.
3
Select
“Group Scan
” and press
the SET button
.
4
Select “Group” or “Full Group” and press the SET button.
Check the available frequencies in the selected group.
Check the frequencies of all groups.
To Next Page
Loading...
Need help?
General
