36
Changing presets
1
Press the SET button on the cue mode main screen.
2
Press the UP/DOWN button to select “Edit” and press the SET button.
3
Select the preset you wish to change using the UP/DOWN button and press the SET button.
4
Press the SYNC button.
Receiver is in standby for communication.
5
Turn the transmitter's control dial to select "RX SYNC" and press the control dial.
• Pressing and holding the control dial (about 2 seconds) will immediately display the "RX SYNC" screen.
6
Move the cursor to "SYNC START" and press the control dial.
• Transmitter is in standby for communication.
7
Place the IR sync window of the receiver so it is facing the IR sync window of the transmitter
• Wait several seconds until communication is established.
Once synchronization is complete, the preset is overwritten.
Deleting presets
1
Press the SET button on the cue mode main screen.
2
Press
the UP/DOWN button to select “Delete” and press the SET button.
3
Select the preset you wish to delete using the UP/DOWN button and press the SET button.
The preset is be deleted.
To Next Page
Loading...
Need help?
General
