65
ATW-R3250
?
The power can't be turned on
• Confirm that batteries are in place.
• Confirm that batteries are not depleted.
• Confirm that batteries are inserted in the right direction.
?
There is no voice / The voice level is low
• Check to see if the transmitter and receiver are on the same chan
nel.
• Check that the receiver's ON/OFF volume knob is not turned off.
• Confirm that the antennas are correctly connected.
• Confirm that the audio output isn't set to the minimum level.
?
Sound is distorted
• Confirm that the audio output level isn't too high.
• Confirm that the volume of any external device isn't too high.
• Check to see if the receiver's gain setting is too high.
?
There is unwanted noise
• Make sure there are no noise sources such as fluorescent lights or electrical equipment near the receiver.
• Confirm that each transmitter is using a different frequency.
?
Low battery is displayed even though the battery was just replaced
• Check the battery settings.
To Next Page
Loading...
Need help?
General
