●
Status indication S0007 displays an error.The error Thermoswitch is displayed
when selecting Details.
The motor has to cool down before the operation can be resumed. Depending on
the parameter setting, the fault signal is either automatically reset or the fault signal
has to be reset using the push button Reset in selector switch position LOCAL.
For further information to this topic, please refer to Manual (Operation and setting).
57
SA 07.2 – SA 16.2/SAR 07.2 – SAR 16.2 Control unit: electromechanic
AC 01.2 Intrusive Corrective action
To Next Page
Loading...
