AUMA SAEx 07.2 User Manual

6910.5.1. End position CLOSED (black section): set
6910.5.2. End position OPEN (white section): set
7010.6. Intermediate positions: set
7010.6.1. Running direction CLOSE (black section): set
7110.6.2. Running direction OPEN (white section): set
7110.7. Test run
7110.7.1. Direction of rotation at mechanical position indicator: check
7210.7.2. Direction of rotation at hollow shaft/stem: check
7310.7.3. Limit switching: check
7310.7.4. Reference operation position feedback: perform
7310.8. Close switch compartment
7511. Commissioning (optional equipment settings)...................................................................
7511.1. EWG 01.1 electronic position transmitter
7611.1.1. Measuring range: set
7711.1.2. Current values : adjust
7711.1.3. LED end position signalling: switch on/off
7711.2. Potentiometer
7811.2.1. Potentiometer: set
7811.3. RWG electronic position transmitter
7911.3.1. Measuring range: set
7911.4. Mechanical position indicator: set
8112. Corrective action....................................................................................................................
8112.1. Faults during commissioning
8112.2. Fault indications and warning indications
8612.3. Fuses
8612.3.1. Fuses within the actuator controls
8712.3.2. Fuse replacement
8712.3.2.1. Replace fuses F1/F2
8712.3.2.2. Test/replace fuses F3/F4
8812.3.3. Motor protection (thermal monitoring)
8913. Servicing and maintenance...................................................................................................
8913.1. Preventive measures for servicing and safe operation
9013.2. Disconnection from the mains
9013.2.1. Disconnection from the mains with KT/KM electrical connection
9113.2.2. Disconnection from the mains with KP/KPH and KES electrical connection
9213.3. Maintenance
9213.4. Disposal and recycling
9414. Technical data.........................................................................................................................
9414.1. Technical data Multi-turn actuators
9714.2. Technical data Actuator controls
10214.3. Tightening torques for screws
10315. Spare parts.............................................................................................................................
10315.1. Multi-turn actuators SAEx 07.2 – SAEx 16.2/SAREx 07.2 – SAREx 16.2 KT/KM
10515.2. Actuator controls ACExC 01.2 KT/KM
10715.3. Actuator controls ACExC 01.2 KP/KPH
10915.4. Actuator controls AUMATIC ACExC 01.2 KES
113Index........................................................................................................................................
4
SAEx 07.2 – SAEx 16.2/SAREx 07.2 – SAREx 16.2 Control unit - electromechanical
Table of contents ACExC 01.2 Intrusive Modbus RTU

AUMA SAEx 07.2 Specifications

General

Brand	AUMA
Model	SAEx 07.2
Category	Controller
Language	English