18
LIUDJR000_eng-00
General operating instructions
AUTEC - Dynamic Plus series
8.2 START pushbutton
The START pushbutton is used to:
- start the Radio Remote Control (see paragraph 8.9),
- activate the horn when the Radio Remote Control is started.
8.3 STOP pushbutton
When the STOP pushbutton is activated, the Machine stops and
the Transmitting Unit switches o. To start the Radio Remote
Control again and enable it to control the Machine after the STOP
pushbutton has been pressed, you need to:
- make sure that the working and usage conditions are safe,
- turn the STOP pushbutton in the arrow direction to unlock it,
- start the Radio Remote Control following the procedure
described in paragraph 8.9.
The STOP pushbutton should be pressed when it is necessary to stop the
Machine immediately whenever a dangerous condition occurs.
The Machine Manufacturer and/or the Installer must provide the instructions
and warnings concerning possible risks that may originate from the Machine
stop (by way of example: movement inertia, swinging load…).
To Next Page
Loading...
Need help?
General
