AUTEC Dynamic Plus Series - Advanced Operations and Unit Management; Battery Removal and ID Memory; Radio Remote Control Startup and Command Activation

24
LIUDJR000_eng-00
General operating instructions
AUTEC - Dynamic Plus series
8.7.2 Battery removal
Push the battery towards the contacts on the Transmitting Unit (3) and remove it from the
housing (4).
When the Transmitting Unit is not in use, remove the battery if possible.
8.8 ID internal tx memory
The "ID internal tx memory" is a key containing the address that is used to code messages
exchanged between the Transmitting Unit and the Receiving Unit.
This key, if present, is inside the Transmitting Unit.
The Transmitting Unit has an "ID internal tx memory" if the Unit has a mechanical key, and
not the "Key ID 0-1", as its power keyswitch (see paragraph 8.1).
S/N:
XXXXXXX
S/N:
XXXXXXX
S/N:
XXXXXXX
A
A
ID internal tx
memory
8.9 Starting up the Radio Remote Control
Starting up the Radio Remote Control consists in establishing a radio link between the
Transmitting Unit and the Receiving Unit.
The Radio Remote Control start up is protected by a power keyswitch to
prevent unauthorised use of the Machine.
Insert the power keyswitch by performing the following procedure, to activate
the Radio Remote Control.