AUTEC - Dynamic Plus series
Malfunction signalled by the Transmitting Unit 39
LIUDJR000_eng-00
11 Malfunction signalled by the Transmitting Unit
11.1 Red LED [B] and green LED [A]
The table below lists malfunctions that are signalled by LEDs on the Transmitting Unit and
the solution to those malfunctions.
If the problem persists after attempting the suggested solution, contact the support service
of the Machine Manufacturer.
Light signals Possible reason Solutions
The green LED blinks
fast.
The red LED
a
blinks for
3.5 minutes.
The battery is not suciently
charged or the Transmitting
Unit has been on for eight
hours
b
.
The battery needs to be replaced
with a charged one (see paragraph
8.7).
The green LED repeats
one of the following
sequences: ONE or
TWO blinks and a
pause.
The red LED
a
blinks for
3.5 minutes.
The green LED repeats
the sequence: three
blinks and a pause.
The red LED
a
blinks for
3.5 minutes.
The Transmitting Unit has been
on for eight hours
b
.
You need to switch o the
Transmitting Unit and start the
Radio Remote Control again.
The green LED is o.
The red LED
a
has ONE
very long blink.
The Transmitting Unit does not
work correctly.
Contact the support service of the
Machine Manufacturer.
At Radio Remote
Control start up,
the green LED is o
and
the red LED
a
has ONE
long blink
c
.
The STOP pushbutton is
pressed.
Unlock the STOP pushbutton. If
this signal persists, contact the
support service of the Machine
Manufacturer.
At Radio Remote
Control start up,
the green LED is o
and
the red LED
a
has TWO
long blinks
c
.
The Transmitting Unit does not
work correctly.
Perform the address storage
procedure (see paragraph 8.16.1).
If this signal persists, contact the
support service of the Machine
Manufacturer.