28
LIUDJR000_eng-00
General operating instructions
AUTEC - Dynamic Plus series
8.14 "Data Feedback" function
The "Data Feedback" function acts through the LED array and/or the display. The User receives
information and/or signals concerning some particular situations and the movements of the
controlled Machine by means of this function.
During normal Radio Remote Control operation, pay particular attention to the indications
displayed and signalled by the display and/or through the LEDs: they can be helpful to
evaluate the Machine working status.
Any information shown and signalled on the display and/or through the
"Data Feedback" LEDs can never be considered or used as a safety signal
or for legal metrology.
When operating and moving the Machine, remember that the Radio Remote
Control does not operate autonomously when potential hazardous situations
are displayed and signalled.
8.14.1 Operation with display
If the Transmitting Unit has a display, it is possible to show warning icons, the measurements
collected from the Machine and their description.
The Machine Manufacturer chooses which information are displayed and the way they are
displayed (icons and/or measurements and/or descriptions).
The battery level and the quality of the radio link are also always indicated.
8.14.2 Operation with LED
If the Transmitting Unit has an LED array for the "Data Feedback" function, specic Machine
conditions are signalled if they are illuminated (by way of example: load limits, limit switch).
The signalled conditions depend on the settings chosen by the Machine Manufacturer.
To Next Page
Loading...
Need help?
General
