AUTEC - Dynamic Plus series
Instructions for the User 31
LIUDJR000_eng-00
9 Instructions for the User
The chapter "Instructions for the User" in "Part A" of the Instruction Manual contains the
warnings for the use that add to those provided in this chapter. Therefore, please refer to
that part of the Manual.
The following instructions refer to general usage situations for the DJR Transmitting Unit,
and indicate how people should or should not behave when using the Unit: they do not cover
any possible risk situations and/or drawbacks that may depend on specic applications of
Autec Radio Remote Controls.
However, instructions given in the following paragraphs do not replace nor complete the
instructions that must be provided by the Manufacturer of the Machine where an Autec Radio
Remote Control (to which the DJR Transmitting Unit belongs) is installed.
9.1 Usage restrictions
If the Radio Remote Control User wears electronic devices (by way of
example: pacemaker, implantable cardiac debrillator, hearing aids), the
Transmitting Unit must be kept at least 15 cm away from those devices
when in use.
9.2 User behaviour
Besides the instructions contained in the General Part (Part A) of the Instruction Manual,
when using the DJR Transmitting Unit, the User must:
- observe and comply with all instructions and warnings provided by the Machine
Manufacturer;
- observe and comply with all instructions and warnings provided by the Installer;
- observe and comply with all instructions and warnings provided by the Person responsible
for the Machine commissioning or making the Machine available for work;
- observe and comply with all instructions and warnings provided in the Radio Remote
Control Manual;
- observe and comply with all applicable Laws, Regulations and Standards, even local.
- follow and put into practice the working instructions he received, and/or those he must
be aware of because of his work and his tasks;
- avoid using the Radio Remote Control if he has not been properly trained and prepared,
and if he has not been qualied for its use by the Person responsible for the work;
- make sure that the Transmitting Unit and the Receiving Unit are whole and work perfectly;
- make sure that the Machine reacts correctly to the commands activated by the Autec
Radio Remote Control;
- not perform any operation if the tests mentioned in the previous two points did not give
positive results;
To Next Page
Loading...
Need help?
General
