AUTEC Dynamic Plus Series User Manual

40
LIUDJR000_eng-00
Malfunction signalled by the Transmitting Unit
AUTEC - Dynamic Plus series
Light signals Possible reason Solutions
At Radio Remote
Control start up,
the green LED is o󰓐
and
the red LED has THREE
long blinks
c
.
The battery is very low.
The battery needs to be replaced
with a charged one (see paragraph
8.7).
At Radio Remote
Control start up,
the green LED is o󰓐
and
the red LED
a
has FOUR
long blinks
c
.
The SAFETY command is
activated (see Technical Data
Sheet).
Bring the actuators to the rest
position. If this signal persists,
contact the support service of the
Machine Manufacturer.
At Radio Remote
Control start up,
the green LED is on
and
the red LED
a
has ONE
to FOUR long blinks
and some short blinks
c
.
At least one of the actuators
corresponding to commands
D2-D20, A1-A8, H1-H8 and L1-
L8 is activated.
Bring the actuators to the rest
position. If this signal persists,
contact the support service of
the Machine Manufacturer. If
necessary, it is possible to identify
the activated command looking up
the table in paragraph 11.3.
a. Whenever the red LED illuminates, the acoustic signal device activates.
b. After this signal, the Transmitting Unit switches o󰘯.
c. Press START pushbutton and hold it down until the Transmitting Unit automatically switches o󰘯.

AUTEC Dynamic Plus Series Specifications

General

Brand	AUTEC
Model	Dynamic Plus Series
Category	Remote Control
Language	English