AUTOFRY Models FFG-10 and MTI-10 Operator's Manual
Let's Get Cooking !
Starting the AUTOFRY
• With the main door closed and locked, press the ON button to begin
heating the oil.
• The O WAIT light will illuminate on the keypad and the exhaust fan will
start to run.
• The current oil temperature will appear on the keypad. This display will
be delayed approximately 12 seconds on the AUTOFRY equipped with
the RTD.
• When the oil temperature reading is between 190°F - 220°F the wire
food basket will complete one test cycle. At this time you may hear the
basket hitting the sidewall of the AUTOFRY. This is a normal condition.
Should the display go blank at this time simply press the ON button to
continue heating the oil.
When the oil temperature at the display reaches 300°F press the OFF
button at the keypad. Unlock and open the main door to check the oil
level. Add oil, if necessary, to fill the oil pot to the "FILL" line.
Close and lock the main door and press the ON button to re-start
the AUTOFRY.
The AUTOFRY equipped with the RTD will allow you to begin cooking at 300° F
however, we recommend that you wait until oil temperature has reached 350°F.
The AUTOFRY equipped with the thermocouple will be ready at 340°F. It takes the
AUTOFRY between 12-20 minutes to heat the oil to 350°F.
Although the heating element is programmed to stop heating at 350°-354°F,
the oil temperature can go as high as 365°F due to the circulation of the oil
in the oil pot. This is a normal condition.
MTI FormOP-0010 Rev. 005 5/98
E167654
To Next Page
Loading...