AUTOFRY FFG-10 - Questions and Answers

AUTOFRY Models FFG-10 and MTI-10 Operator's Manual
Questions and Answers (cont.)
Q:
Why does my food come out oily and under
-
cooked?
A:
First, check that you have entered the correct cook time. It may be that
the
temperature
-
sensing plug
has become fouled with oil or is not
properly seated in its
socket
at the bottom of the
heater box
.
Check that the
high limit
, located on the underside of the heater box
(see page
2,
Figure
1).
Q:
My keypad is displaying
A04
and the AUTOFRY is "beeping"!
A:
First press the
OFF
button or un-plug the AUTOFRY. This will clear the
display and silence the "beeping".
A04
is an error message for the basket motor. One of several things can
cause this:
1. A
wire
food basket
that is not properly installed. Ensure that the
basket rod
is seated correctly into the
basket cam
and the
receiver
clip.
2. A power interruption during a
cook cycle
. Remove the
basket
, enter
a short
cook cycle
then replace the
basket
.
3. Although the
basket motor
is very durable, it is a moving part. All
moving parts are subject to malfunction. If this is the case please call
for service.
Q:
The display on the AUTOFRY reads
A06
.
A:
You
must call our customer service center immediately
at
1
-
800
-
348
-
2976
Ext.
124.
Q:
The display on the AUTOFRY reads
A07
.
A:
Begin by pressing the
OFF
button on the
keypad
to clear the display.
A07
is a frequency conflict error. Un-plug the AUTOFRY and wait 2-5
minutes then plug the
AUTOFRY
back into main power and re
-
start the
unit. If the
A07
reoccurs please call for service.
Q:
The display on the AUTOFRY reads
A08
.
A:
Begin by pressing the
OF
F
button on the key pad, wait 2-5 minutes then
re-start the AUTOFRY.
A08
is a temperature fluctuation error. Anytime
the oil temperature fluctuates by
50°
F in a five
-
second period this error
code will be displayed.
MTI FormOP-0010 Rev. 005 5/98
E167654
28