AUTOFRY Models FFG-10 and MTI-10 Operator's Manual
AUTOFRY Models FFG-10 and MTI-10 Set-up and Installation
The AUTOFRY comes from the factory complete with everything you will need to start
cooking with the exception of food and oil. By following these simple instructions you can
have your AUTOFRY installed and ready to earn profits for you in as little as 30 minutes.
Prepare electrical service.
A licensed electrician in accordance with the National Electrical Code (NEC) and all local
codes must install electrical service. Do not remove or otherwise alter the factory supplied
power cord or plug. Never attach the AUTOFRY to an extension cord. Consult the
Identification Tag for equipment wattage and voltage.
Motion Technology, Inc. will not assume responsibility for any
injuries or equipment malfunctions resulting from non-
conforming electrical installations.
Prepare counter top.
Choose a counter top location that is sturdy, level, easily cleanable and fire resistant.
Stainless steel, fire resistant plastic laminate or solid surface materials are acceptable.
Never use a porous material to prepare food as bacterial contamination could result.
MTI FormOP-0010 Rev. 005 5/98
E167654
To Next Page
Loading...