AUTOFRY Models FFG-10 and MTI-10 Operator's Manual
Charcoal filter removal and leg installation.
• With the AUTOFRY still on its shipping pallet, tilt the unit backward and remove the
charcoal filter from the food exit cutout.
• Install two of the adjustable legs by rotating them clockwise to a hand tight fit into
the front two leg plates located on the underside of the AUTOFRY.
• Tilt the AUTOFRY forward and repeat the leg installation for the rear two legs (see
Figure 2).
. Place on counter.
• Carefully place the AUTOFRY on the counter
• Adjust the legs (as needed) to level the AUTOFRY.
• Make sure that nothing is placed on top of the AUTOFRYwhich could obstruct the
exhaust system.
MTI FormOP-0010 Rev. 005 5/98
E167654
To Next Page
Loading...