Autonics TM Series User Manual

Safety Considerations
VI © Copyright Reserved Autonics Co., Ltd.
Safety Considerations
 Following these safety precautions will ensure the safe and proper use of the product and
help prevent accidents, as well as minimizing possible hazards.
 Safety precautions are categorized as Warnings and Cautions, as defined below:
Warning
Failure to follow the instructions may lead to a serious injury
or accident.
Caution
Failure to follow the instructions may lead to a minor injury
or accident.
 Fail-safe device must be installed when using the unit with machinery that may cause
serious injury or substantial economic loss. (e.g. nuclear power control, medical equipment,
ships, vehicles, railways, aircraft, combustion apparatus, safety equipment, crime/disaster
prevention devices, etc.)
Failure to follow this instruction may result in fire, personal injury, or economic loss.
 Install on a device panel to use.
Failure to follow this instruction may result in fire.
 Do not connect, repair, or inspect the unit while connected to a power source.
Failure to follow this instruction may result in fire.
 Check 'Connections' before wiring.
Failure to follow this instruction may result in fire.
 Do not disassemble or modify the unit.
Failure to follow this instruction may result in fire.
 When connecting the power input and relay output, use AWG 26 to 12cable, and connecting
the sensor input and communication cable without dedicated cable, use AWG 28 to 14cable.
Failure to follow this instruction may result in fire or malfunction due to contact failure.
 Use the unit within the rated specifications.
Failure to follow this instruction may result in fire or product damage.
 Use dry cloth to clean the unit, and do not use water or organic solvent.
Failure to follow this instruction may result in electric shock or fire.
 Do not use the unit in the place where flammable/explosive/corrosive gas, humidity, direct
sunlight, radiant heat, vibration, impact, or salinity may be present.
Failure to follow this instruction may result in fire or explosion.
 Keep metal chip, dust, and wire residue from flowing into the unit.
Failure to follow this instruction may result in fire or product damage.

Autonics TM Series Specifications

General

Brand	Autonics
Model	TM Series
Category	Temperature Controller
Language	English