2. Press MON to display Monitor menu. Use the arrow keys until
2-Oxygen Tests is highlighted, then press ENTER.
3. Use the arrow keys to select an O2 Sensor number, then press
ENTER.
4. Use the tand uarrow keys to select which Oxygen Sensor
Test to view.
5. Press MON to exit the Oxygen Sensor Tests and display the
opening screen.
Before You Start
• [OBD-II] Your scanner must be connected, and the key in
the ON position, before viewing OBD-II Readiness Test
data. If
MON is pressed, and the vehicle has not been
scanned, the scanner will display
Press the Scan
key to Scan New Data
. Refer to “Scanning the
Vehicle” on page 13.
1. Press POWER to display the EZ-
SCAN scanner opening screen.
2. Press MON to display Monitor
menu. Use the arrow keys until
3-Readiness Test is high-
lighted, then press
ENTER.
3. The name of the Readiness Test
will be displayed, followed by its
status. Status is either Completed,
Not Completed, or Not Supported.
• A down arrow on the screen
indicates other test results.
Use the arrow keys to view
these other test results.
Page 30
1-Capture Mode
2-O2 Sensor Tests
3-Readiness Tests
4-Test Results
5-Veh. Information
MIL Status
ON
OXYGEN SENSOR TESTS (CONT.)
READINESS TEST - OBD-II
To Next Page
Loading...
