Scan will be displayed on the
screen. Press
ENTER to start
scanning the vehicle
computer/sensors. (Pressing
SCAN again will abort Scan
mode and display the opening
screen.)
5. Initializing will be dis-
played when entering the DCL
scan. A normal scan can take
up to one minute or longer.
6. After the scanner has read all the data from the vehicle, the
Scan Successful message will be displayed on the screen,
followed by the opening screen.
Operational Data Items
To see a description of each of the Operational Data Items for your
vehicle, refer to “Ford DCL Operational Data Items” on page 57.
Before You Start
• Your vehicle must be scanned before viewing the KOEO
codes. If
DATA is pressed, and the vehicle has not been
scanned, the scanner will display
Press the Scan
key to Scan New Data
. Refer to “Key ON, Engine
OFF (KOEO) Scan” on page 33.
The EZ-SCAN scanner DOES NOT need to be connected to the
vehicle to view the scanned data. The vehicle engine configuration
and data will remain in the scanner’s memory until a vehicle is
scanned again. This allows you to review the data at a later time,
or to use EZ-PC to load the data into a computer.
Page 39
! Scan !
*Successful*
SCAN THE DCL DATA - FORD (CONT.)
VIEW THE KOEO CODES - FORD
To Next Page
Loading...
