NOTE: If the communication link with the vehicle is broken during
Monitor mode, the number in the lower right corner will
stop flashing.
6. Use the tand uarrow keys to step through the sensors (1 at a
time), and the
pand qarrow keys to page through the sensors
(10 at a time) to view their real-time data.
7. When you are done viewing real-time data, press MON. The
number in the lower right corner will stop flashing.
8. Press DATA to exit Data mode and display the opening screen.
Before You Start
• Clearing Trouble Codes will remove any Trouble Codes
from the vehicle’s computer. You can use this feature to
make sure vehicle repairs were done correctly by doing a
new scan after clearing the codes.
• Your vehicle must be scanned before clearing trouble
codes. If
DATA is pressed, and the vehicle has not been
scanned, the scanner will display
Press the Scan
key to Scan New Data
. Refer to “Key ON, Engine
OFF (KOEO) Scan” on page 33, “Key ON, Engine Running
(KOER) Scan” on page 35, or “Data Communications Link
(DCL) Scan” on page 38.
Clearing Trouble Codes
1. Make sure the EZ-SCAN scanner cable is correctly connected to
the scanner and to the vehicle. Turn the vehicle ignition key OFF
for at least 10 seconds, turn the key ON, then press
POWER.
2. Press DATA to display the Data menu. Use the arrow keys until
4-Clear Codes is highlighted, then press ENTER.
3. ENTER to Clear will be displayed on the screen. Press
Page 45
CLEAR TROUBLE CODES - FORD
VIEW THE DCL DATA - FORD (CONT.)
To Next Page
Loading...
