In the Event of a Pre Alarm
Operator's Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-OPERATE/FGB Rev. B, 2009-10-28,
Autronica Fire and Security AS
Page 33
Step Actions to be taken Display Indication Audible Indication
Comments: In this example, a total of 3 points are in Pre Alarm state. If you want to view
detailed point information before investigating the scene(s), go to step 5. If
not, investigate the scene(s), then go directly to step 7.
4
Investigate the scene(s)
and carry out the
necessary actions.
5
To select a point, scroll
with the arrow up/down
buttons.
6
To view detailed point
information, press
then scroll downwards
to see all information.
Comments: If you want to view detailed information for another point;
move back using the Cancel button
, then select another point in
step 5 and repeat step 6. If not, go directly to step 7.
7
To acknowledge a Pre
Alarm, press the red
Silence button.
Comments: When the situation is under control (smoke is exhausted, new glass replaced
in the manual call points, etc.), the system should be returned to normal
operating mode (step 8).
8
Press the green Reset
button.
Comments: The red Pre Alarm indicator goes off, and the panel enters its idle state.
To Next Page
Loading...
Need help?
General
