Menu Mode
Operator's Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-OPERATE/FGB Rev. B, 2009-10-28,
Autronica Fire and Security AS
Page 42
10. Menu Mode
10.1 Menu Structure
The Menu Stucture is accessed when entering Menu Mode. The
Menu Structure for Autroprime Interactive Fire Detection System
(including all access levels) is found in Appendix.
10.2 How to Enter Menu Mode
To enter the Menu Mode from operation mode or the panel’s idle
state, press and hold down the Enter button
for a few seconds.
The number and type of menu selections that appear in the display in
Menu Mode depends on the current access level (1, 2 or 3).
If the panel is set to access level 1 (no key or password), the following
is shown in the display:
If the panel is set to access level 2 (the key is turned clock-wise), six
different menu selections are shown in the display, including System
Status, Disable, Enable, Show Unit Properties, Report and Enter
Service Mode. If the panel is set to access level 3 (Service Mode is
entered using a password), the seventh menu selection Exit Service
Mode is shown in the display.
If no button is operated within a preconfigured timeout, the menu will
be terminated and the operator panel will re-enter operation mode.
To manually re-enter operation mode, press and hold down the
Enter button
for a few seconds.
NOTE:
The Silence
button and the
Reset button can
be operated both
in Menu Mode
and in Operation
Mode.
To Next Page
Loading...
Need help?
General
