Autronica Autroprime - TCP;IP Port Settings (Ethernet); ESPA Interface Settings

Show Unit Properties
Operator's Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-OPERATE/FGB Rev. B, 2009-10-28,
Autronica Fire and Security AS
Page 63
14.14.2 TCP/IP Port Settings (Ethernet)
Using the Enter button after selecting TCP/IP port settings
reveals the following properties:
 own IP address
 gateway IP address
 subnet mask
14.14.3 ESPA Interface Settings
Using the Enter button after selecting ESPA interface settings
reveals the following properties:
Show Settings
 name
 port (not in use, serial or TCP/IP)
 port number
 restore factory settings or not (No/Yes)
 display size (default 128), then
press Enter.
 line length (default 12)
 alphabet type (7 bits, 8 bits, or GSM)
 fault detail (Yes/No)
 startup message
Show Events
 alarm
 pre-alarm
 fault
 supervisory
 startup
 test
Show Receivers
 user name
 receiver number
 show (events)