Autronica Autroprime - 14.8 Local Outputs; 14.9 Loop Inputs

Show Unit Properties
Operator's Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-OPERATE/FGB Rev. B, 2009-10-28,
Autronica Fire and Security AS
Page 60
14.8 Local Outputs
Using the Enter button after selecting a local output reveals the
following properties:
 Name
 Unit function
o Fire Alarm Device (FAD)
o Fire Alarm Routing Equipment (FARE)
o Fault Warning Routing Equipment (FWRE)
o Disable Out
o General Output
o RESET Out
o Silent Alarm Output
o Silence Out
o Small Alarm Output
Using the Function button
after selecting a local output gives the
following menu selections (note that the menu selections are not
applicable to all outputs):
Not applicable to Fire Alarm Devices, Fire Alarm Routing Equipment
and Fault Warning Routing Equipment:
 Show Activating Detection Zones
 Show Activating Points
 Show Activating Inputs
 Show (activating) Activation Groups
 Show Activating Outputs
Not applicable to Fire Alarm Routing Equipment and Fault Warning
Routing Equipment:
 Show Connected Units
14.9 Loop Inputs
Using the Enter button after selecting a loop input reveals the
following properties:
 Name
 Unit function
Using the Function button
after selecting a loop input gives the
following menu selections:
 Show Connected Units