27
400 Series Operating instructions
Seat - Seat belt and seat adjustments
The seating capacity of the loader
is one person only. Never carry
passengers on any part of the loader
or with any attachment.
Always use seat belt while driving. Clean the seat belt
regularly with a sponge, warm water, and soap. Use
compressed air to clean the buckle.
Replace the seat belt if any damage is seen, or if the seat
belt is exposed to high load or chemicals.
Make sure that the seat is properly adjusted to keep
vibrations transmitted by the seat at minimum. Long term
exposure to vibrations may cause health effects. Also, as
far as possible, keep the operating terrain in good condition
to minimize vibrations.
Standard seat
The distance of the seat from the steering wheel can be
adjusted with the lever which is located under the front
edge of the seat.
Suspension seat
The suspension seat is equipped with seat belt, arm rests
and heating, and has the following adjustments:
1. Suspension adjustment
• by turning the knob counterclockwise suspension
gets harder, by turning it clockwise the suspension
gets softer
2. Angle of the back rest
• the angle of the back rest can be adjusted by turning
the knob
3. Seat position
• the distance of the seat from the steering wheel can
be adjusted with the lever which is located u n d e r
the front edge of the seat
4. Arm rest angle adjustment
• The angle of the arm rest can be adjusted by turning
the roller under the arm rest
Seat heater
The suspension seat is equipped
with an electric seat heater. Seat
heater switch and indicator are
located on the dashboard.
2
1
3
4
WARNING
To Next Page
Loading...
