34
400 Series
Work light kit (option)
The loader can be equipped with
extra work lights, making it easier
to work in low light. The lights are
operated with the switch on the
control panel (see page 24).
Headlight, beacon, blinker & reflector kit
(option)
This optional equipment enables
road trafc registration in certain
countries. Requirements vary in
different countries, please consult
your local AVANT distributor.
Warning beacon (option)
The beacon can be removed
quickly by unturning its retaining
screw and then by pulling the
beacon out. Place the protective
seal on the beacon stand to prevent
water entering and damaging the
connectors. Handle beacon with
care. The beacon is sealed and
its inner components cannot be
replaced or repaired by user.
Risk of electric shock - do not use or
service a faulty beacon.
Beacon includes high-voltage
components. Do not use or repair
damaged beacon, replace with new
one.
Light bar (option)
Flashing lights on the light bar, only
available on DLX cab.
Trailer coupling (option)
The loader can be equipped, as
an option, with a trailer coupling.
There are two types available:
a 50 mm ball hitch and a 50 mm
ball hitch with towing pin. Both can
be mounted either directly on the
rear bumper or on the extra back
weight. Max. allowed vertical load
of the trailer coupling is 6900 N,
max. towing load is 6000 N.
Make sure that the weight on the
trailer is distributed correctly so that the trailer cannot
cause an upward lifting force on the trailer coupling.
Extra counterweights (option)
The loader can be equipped with
extra counterweights that are
mounted on the rear bumper.
Max. amount of extra weights
(29 kg/pcs) is 3 pcs. If the machine
is tted with an extra weight with
trailer coupling, max. amount of
extra weights is 1 pcs. The loader
can also be equipped with an
extra side weight kit (80 kg) which
mounts behind the rear wheels.
Extra back weight 29 kg
Rear side weight (2x40 kg)
Operating instructions
WARNING
To Next Page
Loading...
