CHAPTER 3
Instructions, use and maintenance manual
Page 22
Drago PZero
3.2. NOISE
The noise levels have been measured in accordance with the requirements of UNI EN 11200 and UNI EN ISO
3746. During the operating cycles, the levels of exposure to noise for appointed personnel do not exceed 76 dB.
The actual noise levels of the installed machine during operation on site in a manufacturing process differ from
those detected, as the noise is inuenced by factors such as:
• type and features of the site;
• type of processed material;
• other adjacent machines in operation.
It is the user's responsibility to apply the consequent preventive and protective measures, in compliance with the
law of the country of installation and use of the machine.
3.3. VIBRATIONS
The machine does not produce any vibrations due to the constructive type and the absence of moving components.
3.4. RESIDUAL RISKS
This machine was designed to guarantee the essential safety requirements for the operator. Safety has been
incorporated, as much as possible, into the design and construction of the machine; however, there are risks from
which the operators must be protected, especially during:
• transport and installation;
• normal operation;
• adjustments and ne tuning;
• maintenance and cleaning;
• disassembly and dismantling.
For each residual risk, there is a description of the risk and of the area or part of the machine subject to that
residual risk (unless the risk is valid for the entire machine). Information is also provided on proper use of the
personal protective equipment foreseen and required by the manufacturer.
To Next Page
Loading...
