Avaya 9608 - Chapter 12: Receiving your messages; Logging into your voice mail

Customizable system parameters for SIP-based 9600 Series IP Deskphones
Issue 3 January 2014 73
CONF_TRANS_ON_
PRIMARY_APPR
0 Affects the idle line that is selected when initiating a
conference or transfer on a call appearance or a
bridge appearance. The valid values are:
● 0
- When initiated from a call appearance, an
idle call appearance is used if available. If
an idle call appearance is not available, an
idle bridge appearance is used.
- When initiated from a bridge appearance,
an idle bridge appearance for the same
extension is used if available. If an idle
bridge appearance is not available,
AUTO_SELECT_ANY_IDLE_APPR
defines the behavior.
● 1
- An idle call appearance is always used if
available regardless of whether the
operation was initiated from a call
appearance or bridge appearance.
- If an idle call appearance is not available,
the conference or transfer fails.
CONTROLLER_SEARCH_INTE
RVAL
16 Time in seconds that the deskphone waits to
complete the maintenance check for monitored
controllers. Valid values are 4 - 3600 (seconds).
COUNTRY USA Country of operation for specific dial tone
generation. This is a specific text string specifying
the country in which the device operates (e.g.
"USA", "France", Germany"). See Appendix
B: Countries with specific network progress tones
for a list of applicable countries.
COVERAGEADDR " " (Null) The URI to which call coverage is sent to in failover
(non-Avaya) environments only.
CURRENT_LOGO " " (Null) Defines the selected background logo on display, if
any.
The value of this parameter indicates if a custom
logo is currently selected (non-empty string) or a
built-in default logo is used (empty string or not
set).
The user can also set the current logo from the
deskphone, through the Avaya menu. However, to
use a custom logo, the logo must be defined in the
LOGOS configuration parameter.
DATEFORMAT %m/%d/%y Formatting string defining how to display the date in
the top line and the call log.
Parameter Name Default
Value
Description and Value Range