Putting a conference call on hold
About this task
When you put a conference call on hold, the other parties can still talk to each other.
Procedure
1. Press Hold during a conference call.
2. Press Resume or OK to resume the conference call.
Dropping the last participant from a conference call
About this task
Use the following procedure to drop the last participant added to the conference call. Once you drop
the last added participant, you cannot use the procedure to drop other participants. The deskphone
plays an error tone if you try to use the drop method again. If you add another participant after
dropping the last added participant, you can use the drop method again to drop this participant.
Note:
This feature is applicable only for a conference call of the AST 1 type.
Procedure
1. From the Phone screen, select your active call.
2. Press Drop once the conference is up.
The deskphone drops the last added person from the conference.
Viewing the details for a conference
About this task
Note:
Depending on which server your extension is configured in, you might not be able to see the
details of a conference. If you are not able to view the details of a conference, contact your
system administrator.
Procedure
1. On the Phone screen, select your active call.
2. Press Conf.
Using the conference feature
October 2015 Using Avaya 9608/9608G/9611G IP Deskphones SIP 52
Comments on this document? infodev@avaya.com
To Next Page
Loading...
