18
Note: To turn logging of bridged lines on or off, select Log Bridged Calls and press
Change or OK.
7. Press Change or OK to turn call logging on or off.
8. Press Save.
To add a new contact:
1. Press Contacts.
2. Press New.
3. Enter the name using the dialpad.
Note: Press the number key that corresponds to the letter or number you want to enter
until the letter or number is displayed. Pause before entering the next character if the
characters are on the same key. Enter remaining letters or numbers. If you want to
delete the last character, press Bksp. If you want to remove a letter, number, space, or
symbol that is in the middle of the text you entered, use the left and right navigation
arrows to place your cursor after the character you want to remove. Once your cursor is
in the correct position, press Bksp to remove the character to the left of the cursor. To
change between upper and lower case letters, or to enter numbers, press More > Abc.
To cycle through the options (Abc/123/abc/ABC), press ABC again to until the type you
want to use is displayed. To enter characters that are not on your dialpad, press More >
Symbols and select the symbol you want to use then press OK to select the symbol. To
delete all text and start over, press Clear.
4. Select the next field.
5. Enter the (primary) telephone number.
6. Select the next field.
7. Select the type of number entered (general, work, mobile, home).
8. If you have another number for this contact, repeat Steps 5 through 7. You can add up
to three numbers for this contact.
9. Press Save or OK.
o The new contact is saved.
To add an entry from the call log to your Contacts list:
1. Press History.
2. Select the number you want to add to your Contacts list.
3. Press +Contact.
To Next Page
Loading...
Need help?
General
