Upgrading R6csi/R7csi/R8csi to Avaya Communication Manager on an Avaya DEFINITY Server CSI
196 Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
Verify the Upgrade
To verify the upgrade:
1. Type status system 1 and verify that the system is in a normal state.
2. Type display alarms and press Enter.
If the system is not alarm-free, take the needed corrective actions.
3. Type list configuration software-version and press Enter. Verify the Avaya
Communication Manager configuration.
4. Type display communication links and press Enter.
Status each of the links.
Note: ISDN-PRI D-channel links no longer appear on this screen. (For Release 7 and
later, ISDN-PRI resides on the network packet circuit pack.) For Release 7 and
later, the only way to determine if an ISDN-PRI D-Channel is up is to type status
signaling group and press Enter.
5. Type list signal press Enter. For each signal, type status signal and press Enter.
Note: Check the ISDN-PRI D-channel links here.
6. Execute the following commands and verify that the information is correct:
list station
list trunk-group
list hunt-group
list data-module
Enable Scheduled Maintenance
To enable scheduled maintenance:
1. Type change system-parameters maintenance and press Enter.
2. Check the Start Time and Stop Time fields.
To Next Page
