- cls FNA FBA MWA
Note:
Ensure that message waiting indication is enabled in Customer Data Block (LD 15):
IMS must be set to YES; MCI must be present in the OPT prompt (FTR_DATA).
Operating the MSMN feature
T
o activate the MSMN feature, perform the following steps:
• Turn the handset on within the coverage range of a visited DECT system (Remote Call
Forward is activated).
OR
Enter the coverage range of a visited DECT system from another DECT system with the
handset turned on (Remote Call Forward is activated).
To deactivate the MSMN feature, perform the following steps:
• Turn the handset off within coverage range of the visited DECT system.
OR
Turn the handset on at the home DECT system. (Any CFW related to the handset is
cancelled.)
OR
Enter the coverage range of the home DECT system with the handset on. (Any CFW related
to the handset is cancelled.)
Multiple Gatekeepers Configuration
Multiple Gatekeepers is a special configuration option that allows using SIP
DECT in
Survivable Branch Office configuration (CS1000) or in Load Balancing configuration.
Note:
The Multiple Gatekeepers option can be used for Survivable Branch Of
fice configuration
(CS1000) or for Load Balancing configuration, but not for both of them at the same time.
Survivable Branch Office Configuration (Communication Server
1000)
T
o configure SIP DECT for Survivable Branch Office Configuration, you must enable Multiple
Gatekeepers option in the IP DECT Configurator. One SIP Proxy server must be the Main
Office SIP Line Gateway; the second SIP Proxy server is the Branch Office SIP Line Gateway.
Multiple-site mobility network configuration
SIP DECT Fundamentals October 2012 117
To Next Page
Loading...
Need help?
General
