Troubleshooting
The
Troubleshooting section provides settings you can check to resolve some common
configuration problems.
•
If DAP is not working on page 169
• If you cannot make calls to or from a DECT Handset with SIPL configuration on
page 170
If DAP is not working
Prerequisites
• The signaling server
, call server, and DAP Controller are configured and connected to the
Ethernet.
• SIP DECT is configured in the IP DECT Configurator.
If DAP is not working, ensure that the DHCP and TFTP servers are configured and running.
If you use the MS Windows DHCP Server, ensure:
• the scope is created
• the IP address range is added
• the scope options are configured
• the scope is activated
• Microsoft Windows DHCP Server is running
If you use the MS Windows TFTP Server, ensure
• Run TFTP Server on this PC is selected
• Windows TFTP Server on this PC is selected
• Microsoft windows TFTP Server (Trivial FTP daemon) is running
• dapcfg.txt and DAP firmware package are presented in the C:\TFTPDROOT folder
If you use a built-in DHCP Server, ensure
• Run DHCP Server on this PC is selected
• the DAP IP range is entered
Troubleshooting
SIP DECT Fundamentals October 2012 169
To Next Page
Loading...
