Use the steps in the following procedure to configure SIP DECT for using Central directory
access.
Configuring IP DECT
1. Open the IP DECT Configurator and click Modify.
2. Select the SIP DECT system that you are running. Click IP Settings.
The IP Settings page appears.
3. Click More.
TheAdvanced IP Settings pane appears.
4. Enter the CDA IP Address and the CDA port.
The IP address is the IP address of the computer running the Central directory
access tool. The port number is the port that is open for Central directory access
on the CDA computer. The default port number is 30160.
5. Click Apply.
6. Click Save System.
7. Click Activate / Deactivate / System Status.
8. Restart the DDS service and restart all DAPs.
Central Directory access tool
SIP DECT Fundamentals October 2012 145
To Next Page
Loading...
Need help?
General
