18. Enter the floor number. Remember that the floor numbers start with “0”. We are adding a second floor,
so this will be floor 1. (However
, in this example the picture/image of the floor says Floor 2.). Click OK.
19. Now you will see an empty floor. You must add a jpg picture to this floor. Click Add new image, as
shown in the screen capture below
.
20. The screen below is displayed. Browse to you second jpg picture/image file. Also fill in the image
location with the same values as the previous image for Floor 0.
Location builder tool
188 SIP DECT Fundamentals October 2012
Comments? infodev@avaya.com
To Next Page
Loading...
