• c--thumb screw
• d--battery pack
• e--guides
• f--thumb screw nut
• g--power cord
• h--power cord receptacle
• i--tripod
Figure 56: Deployment tool battery details
Assembling the deployment tool
1.
Set up the tripod.
Remove the tripod from the carrying case and place it upright. Lock the casters.
2. If required, install the extension arm fitting on the tripod. If not required, go to step
4.
3. If required, secure the extension arm fitting.
Use the Allen key attached to the extender arm to secure the extension arm fitting
Allen screw.
4. Mount the extension arm on the tripod.
Place the brass end of the extension arm into the fitting, so that the keying hole of
the extension arm mates with the retaining thump screw locking device of the tripod
Prepare the tool for deployment
SIP DECT Fundamentals October 2012 211
To Next Page
Loading...
