Figure 67: Cable run in the Cabinet
15.
Connect the RJ45 connector to the 4720 DAP (at the rear side) and push the
Category 5 Ethernet cable into the round foam-free area in the rear side of the
cabinet.
16. Push the 4720 DAP into its position in the foam.
Figure 68: 4720 DAP in position in the cabinet
17. Mount the cover of the cabinet onto the cabinet with the four plastic screws in each
corner of the cover. The cabinet is now closed.
Figure 69: Mounting the cover
Installing 4720 DAP with internal antennas
SIP DECT Fundamentals October 2012 221
To Next Page
Loading...
