Figure 83: Cutting the foam to allow the antenna to fit into it, in the required position
23. Lead the coax cables to the antenna via the groove in the top of the foam and push
the antenna into its final position into the foam.
Note:
Y
ou can change the position of the antenna to the required position in the foam,
by means of turning the antenna or giving it some tilt.
Figure 84: 4720 DAP and directional antenna in their positions
24. Mount the cover of the cabinet onto the cabinet with the four plastic screws in each
corner of the cover
. The cabinet is now closed.
Figure 85: Mounting the cover
Installing a 4720 DAP with external antennas
SIP DECT Fundamentals October 2012 227
To Next Page
Loading...
