Avaya CS 1000 - Page 66

Calculating the number of users without an office
Table 8: Example of the table third row calculation
Estimate for: 1C1 1C2 1C3 1C4 1C5 1C6 1C7
Users inside the cell with
an of
fice
8.4
Users with an office
outside of a cell who walk
into the cell
3.2
Users without an office 0
Users in a cell
Calculating the number of users without an office
1. Calculate the estimate for users in the first cell without an office.
Use the following formula:
2. Enter the result in the row Users without an office.
In the example shown in Figure 33: Example of dividing the coverage area and
recording offices on page
63, no users are without an office.
Totalling the estimate for users in a cell
Table 9: Example of the table first column total
Estimate for: 1C1 1C2 1C3 1C4 1C5 1C6 1C7
Users inside the cell with
an of
fice
8.4
Users with an office
outside of a cell who walk
into the cell
3.2
Users without an office 0
Users in a cell 11.6
Totalling the estimate for users in a cell
1.
Total the number of users in the first cell by adding the three rows in the first
column.
2. Enter the result in the bottom row users in a cell.
For the example in
Figure 33: Example of dividing the coverage area and recording
offices on page 63
, the 1C1 handset estimate equals 11.6.
Site planning and hardware deployment
66 SIP DECT Fundamentals October 2012
Comments? infodev@avaya.com