Safety instructions
AVENTICS | ECS Actuator | R417002911–BDL–001–AA 11
English
handling will invalidate the warranty.
W Under no circumstances the product may be subjected to
mechanical load. Never use the product as a handle or step.
Do not place objects on the product.
2.6 Product- and technology-related safety
messages
Assembly W Always disconnect Marex ECS from the power supply before
assembling the Marex ECS Actuator, connecting or
disconnecting plugs. Secure the system against being
switched on unintentionally.
W Lay cables in such a way that they cannot be damaged and
nobody can trip over them.
W Make sure the transparent cover and plug connections fit
securely to prevent that liquids and foreign particles
penetrate into the product.
Commissioning W Make sure that all electric ports are used or covered. Only
start up products which are fully installed.
Operation W Only allow authorized persons to access the engine control
room.
2.7 Operator‘s obligations
Installation and maintenance work is subject to the country-
specific safety regulations and standards of the application. As
an operator of a ship which shall be equipped with a Marex ECS
Actuator and further components of a ship remote control
system, you are responsible that
W the product is in technically perfect condition,
W the product is used as intended,
W any staff handling the product has read and understood the
documentation,
W users of the product are trained and instructed,
W the regulations related to safety, accident prevention and
environmental protection are complied with.
To Next Page
Loading...
