About this documentation
6 AVENTICS | ECS Actuator | R417002911–BDL–001–AA
1.3.2 Symbols
The following symbols mark notices which are not relevant to
safety but contain useful knowledge for the proper operation of
the product.
1.3.3 Designations
The following abbreviations are used in these assembly
instructions:
Table 2: Hazard classes according to ANSI Z535.6-2006
Warning sign,
Signal word
Meaning
DANGER
Indicates a hazardous situation
which, if not avoided, will result in
death or serious injury.
WARNING
Indicates a hazardous situation which,
if not avoided, could result in death or
serious injury.
CAUTION
Indicates a hazardous situation which,
if not avoided, could result in minor or
moderate injury.
NOTICE
Property damage: The product or the
environment may be damaged.
Table 3: Meaning of symbols
Symbol Meaning
If this information is not observed, the optimal use or
operation of the product cannot be ensured.
O
Single, independent step
1.
2.
3.
Numbered instructions:
The numbers indicate the steps which must be executed
in a given order
To Next Page
Loading...
Need help?
General
