Aventics Marex ECS User Manual

Commissioning
AVENTICS | ECS Actuator | R417002911–BDL–001–AA 41
English
8.5 Setting up the actuator for the gear control
Proceed as follows to store the positions which the actuator’s
lever shall approach (teach-in). It is essential that you store the
positions in the order given in the following instructions.
1. Detach the ball joint from the ball bearing on the actuator
(fig. 19) in order to avoid unintended hitting against the end
positions.
2. Switch the power supply on.
3. Set the slide switch S2 (14) to "ON". The red and green LEDs
flash:
4. Reattach the ball joint on the ball bearing on the actuator (fig
19) and move the lever of the actuator manually so that the
adjusting lever of the gearbox is in the FORWARD position.
5. Push switch S3 to confirm the setting. The red and greed
LEDs stay on for a short time. The position is stored.
6. Move the lever of the actuator manually so that the adjusting
lever of the gearbox is in the NEUTRAL position.
7. Push switch S3 to confirm the setting. The red and green
LEDs stay on for a short time. The position is stored.
8. Move the lever of the actuator manually so that the adjusting
lever of the gearbox is in the REVERSE position.
OFF ---> ON

Aventics Marex ECS Specifications

General

Brand	Aventics
Model	Marex ECS
Category	Control Unit
Language	English