Commissioning
AVENTICS | ECS Actuator | R417002911–BDL–001–AA 33
English
Fig. 13: Settings of switch S1 (printed on type plate)
6. Proceed accordingly to set the function of all other
actuators.
7. After finishing the setting a different function must be
assigned to every actuator. (The rotary coding switches S1
must be set to different figures.)
8.3 Starting the auto-configuration
Auto-config Marex ECS features automatic configuration (auto-config). Only
few steps are required to log on and configure components.
Always perform those steps,
W if you have installed a new Marex ECS,
W if you have replaced a control head,
W if you have enhanced the system and added another control
To Next Page
Loading...
