Assembly
26 AVENTICS | ECS Actuator | R417002911–BDL–001–AA
Keep the cables as short as possible. We recommend only
to use cables which are approved by AVENTICS. Those
W ensure faultless data transmission
W provide safe and sealed plug-in connections
W provide unmistakable connections due to matching colors of
cables and sockets.
7.2.2 Connecting the Marex ECS wiring harness and
further actuators
Follow these steps to connect the Marex ECS Actuator to the
Marex ECS Wiring Harness and optional actuators (see also
fig. 7):
1. Select a grey STATION cable and apply the alternative label
"PROPULSION" which is included in the delivery.
2. Plug the PROPULSION cable into one of the sockets
(6, fig. 8) of the Marex ECS Actuator.
3. Connect the other end of the PROPULSION cable to one of
the PROPULSION plugs on the Marex ECS Wiring Harness.
Further Marex ECS Actuators are either connected to the
second PROPULSION plug on the wiring harness or plugged into
the second socket (6, fig. 8) of the of the preceding Marex ECS
Actuator:
4. If your system includes more than one actuator, relabel
another grey STATION cable and plug it into one of the
sockets(6, fig. 8) of the next actuator.
5. Connect the other end of the cable to the second socket (6,
fig. 8) of the preceding actuator or the second PROPULSION
plug on the wiring harness.
6. Repeat 4. and 5. if you wish to connect more actuators.
Four Marex ECS Actuators can be combined in Marex ECS at
maximum. They can be mounted in any order.
To Next Page
Loading...
Need help?
General
